On a programmable V-cut grooving machine, three settings shape the fold: included angle, cutting depth, and residual web. The included angle determines how open the finished corner appears. A smaller angle creates a tighter fold; a larger one leaves a broader opening. Match the angle to the product’s corner design, not just the cutter specification. Small differences matter.
Set cutting depth against the measured grey board thickness, which can vary across sheets. The remaining uncut layer, or residual web, must be thin enough to fold cleanly but strong enough to hold the outer liner together.
Too much web can resist folding and cause a bulky corner. Too little can split or expose rough fibers. Not every sheet behaves alike.
Check a test groove under the actual production conditions, then inspect the fold for cracking, spring-back, and a visible gap. A neat programmed value can still disappoint when board density or moisture changes.
Record successful settings by board grade and thickness, but verify them when a new batch arrives. That extra check may feel slow; it can prevent a full run of uneven corners.