A pneumatic conveyor performs only as well as its installation allows. Before assembly, confirm the material’s bulk density, moisture, particle size, and tendency to break or cling. These properties affect line diameter, air demand, and conveying mode.
A layout drawing should show pipe routes, bends, cleanout points, filters, and access for inspection. Keep bends gradual where possible; tight turns can increase wear and create stubborn buildup. Support long pipe runs securely, and seal joints carefully. Small details matter. Verify electrical connections, grounding, and dust-control provisions against the equipment instructions and site requirements before startup.
During operation, establish a baseline using pressure readings, airflow, motor load, and throughput. Change one setting at a time, then note the result. Sudden pressure changes, unusual noise, or falling output may signal a blockage, leak, worn elbow, or filter loading.
Stop and isolate equipment before opening lines or inspecting moving parts. Maintenance should include scheduled checks of seals, hoses, filters, rotary valves, and pipe wear, with findings recorded for trend comparisons. Cleaning intervals depend on the material and duty cycle; a calendar alone can miss early problems. Not always. Operators may need to revise the schedule after observing real buildup, especially at low points and bends.